Foundations and installations:
The foundations were built on continuous reinforced concrete footings, calculated based on the loads and other requirements included in the plans, schedules, and technical specifications, in compliance with current codes and regulations, and carried out by leading companies. The installations were completed according to the tender specifications and the standards of URSEA, UTE, IEEE (Institute of Electrical and Electronics Engineers), NEC (National Electrical Code), IEC (International Electrotechnical Commission), NFPA (National Fire Protection Association), and UL (Underwriters Laboratories).
Electrical installation:
- Installation with self-extinguishing PVC conduits.
- Standardized plastic boxes for switches, outlets, light switches, light fixtures, wall lights, telephone wiring (conduits only), CATV, and other installations.
- Quick-connect switches, buttons, outlets, and other fittings, without screws, Conatel brand, Duomo line or similar.
Drainage and water:
- Columns and pipes for primary, secondary, and stormwater drainage, and ventilation, made of PVC pipes and fittings with elastic joints up to 160 mm.
- Primary and secondary drain pipes suspended between the slab and ceiling, rising to the fixtures through openings in the slabs.
- Cold and hot water installation completed with thermofusion pipes.
Finishes:
- For interiors, at least two coats of Gliden Inca brand wall filler will be used.
- White Inca paint for ceilings; for walls, two coats of Inca primer and a finish of two coats of Incalex paint.
- The facade will receive one coat of Gliden pigmented sealer and at least two coats of Inca facade paint (Incafent). On Hº, Aº moldings, Incatech plus.
- Interior woodwork received a primer coat and will be finished with at least two coats of Satincs paint or Sayerlack polyurethane lacquer.
Internal reference: Tera-4889.
